🖐 ブラックジャック | 手持ちのカード

You will receive an activation e-mail. Thank you very much for your understanding. We kindly advise testing with UDP as a first. This is the NetOP IoT Platform address, if you want to use another Platform, please set its IP address. As a first step, you should open the enclosure. To change the settings: 4. STEP 4: Connect your Bluetooth Gateway to the Internet by using either Your WiFi or GSM Sim Card At this point, it should be better to start with WiFi not to face any issue because of Sim Card. And then it will be activated. And insert its antenna. STEP 4. If not, you can detect on which step it is stuck.{/INSERTKEYS}{/PARAGRAPH} Your device should be plug and play and no need to do any configuration. And check it out that the device is on the list. You will receive its data here. After that, you should be seeing its WiFi Hotspot by using your PC or Mobile Phone by searching Wireless Networks you can find this on the below step by step video. We also kindly advise you to test your device on the NetOP platform as a First. After that, you can change the data transmission period by yourselves. STEP 5: Insert NB-IoT Sim Card to the Device Please insert an NB-IoT Sim Card which has NO PIN CODE to the device. Login with your e-mail and password. After that, you may test MQTT as well. Be sure to see Configurator found at COM Port message. By using your WiFi Modem Main page by having a look at IP addresses on your network. You can find this IP address either 1. Otherwise, you can set your APN or IP address by yourselves by using standard Micro USB Cable. {PARAGRAPH}{INSERTKEYS}If it is a smart beacon, please just remove the plastic yellow material. After updating your Driver, please insert a Micro USB cable to the device and also to your Computer. You will receive these files via an e-mail. So, you can detect where on which step the possible problem is on. Click on the device. STEP 6: Activate Power Supply There are 3 different enclosures. Please just skip this step. You should see its default settings as below: 4. Name it as you wish. Below screenshot is an example with Temperature Humidity Sensor, your settings would be different depending on your sensor type. Your device should be plug and play and no need to do any configuration Please update your COM Port Driver by using STM32 drivers. Thank you! And then direct your data from their platform, as an example T-Mobile with 1nce NB-IoT Sim card in The Netherlands. Please install the NetOP Configurator Exe program which works on Windows We will be providing Mac and Linux Versions soon! To be sure that your Driver is updated correctly, you should see STMicroelectronics Com Port as below: If you see Your COM Port It could be different than COM3 as above, please continue with the next steps, otherwise please check your driver and if you have any issue please contact us. Activate your account by using the link in the e-mail.